The best way to Paint a Cinder-Block Wall

The best way to Paint a Cinder-Block Wall

Blocks, also also referred to as blocks that are concrete, are a tough but instead industrial-seeking materials for partitions. Whether employed for an outside backyard wall or as an interior basement wall, paint offers for dressing the dull grey blocks, one answer. Concrete has a area that expels and collects moisture, which could weaken or harm the paint. Proper planning assures a straight paint program that can resist flaking and peeling.

If it was once painted remove any paint in the wall. Use a power washer to remove any paint and grime; scrub places using a wire brush. Allow the wall.

Fill in almost any cracks with the acrylic caulk. Smooth the caulk to the crack and smooth the area using a putty knife. Allow the caulk to dry. Apply another caulk if required to make the region flush with all the cinderblock that is surrounding surface filling.

Spread a dropcloth before the cinderblock wall on the floor. Tape off the floor or surfaces surrounding edges of the wall and the block wall across the bottom so paint does not drip onto them.

Paint the whole wall using a coat of primer that is concrete or a sealer. Apply an even coat using a broad paint brush. Allow it to dry for the time or for four hours.

Paint a coat of exterior latex masonry paint or exterior house paint onto the cinder blocks that are ready. Allow the first coat to dry completely, which usually requires between four and eight hours. Apply another coat following the first coat of paint is dry.

See related